FAQs

Find answers to the most frequently asked questions about our custom wrought iron lighting products & services.

Yes, all our iron lighting products are hand forged by our experienced craftsmen. We take great care in the quality of every product. Each piece is quality inspected for overall appearance.

However, tiny imperfections and slight differences in size and variation may occur in the fixture and the finish. These variations are not considered defects and are to be expected. Slight variations add to the custom look and feel of each of our products.

Each fixture achieves an individual personality created through the hands of our craftsmen. Each premium finish is hand applied to greatly enhance the overall look of the product and give it an authentic aged and elegant appearance.

View some of our iron lighting installations

We ship to all 50 U.S. States and can even ship internationally for overseas orders.

We ship to all states in the USA. Most orders will be shipped by UPS or Freight Carrier at a rate of 10% of the total cost of the order. Tax is NOT applied to shipping cost.

Shipping outside of the USA will require a shipping quote approval.

Read More

All chandeliers come with a canopy and chain that is finished to match the chandelier. 3ft. of chain is included.

Extra chain is available for chandeliers and comes packaged in 1 foot lengths at an additional cost. The standard length of chain provided with the chandelier is 3 feet.

We offer 7 different finish options at no additional charge.

We offer candle sleeves, as shown on the website for each fixture, at no additional cost.

We do not provide bulbs for any fixtures, but we can make bulb type recommendations.

Please call if you need more info on custom candle covers and finish options.

Yes, we offer clear glass or seeded glass at no additional charge. Please contact us for custom glass options.

Yes, we are able to produce many of our outdoor lanterns with natural gas or propane. Please call for individual pricing and availability.

A general guideline is to choose a chandelier that has a diameter equal to one-half the width of the table. The general appearance of the chandelier must be taken into account, too; that is, if it is a light airy piece, you may want it slightly larger than the standard.

Generally there should be 30″ – 36″ between the bottom of the chandelier and the top of the table in a room with an 8′ ceiling. If the ceiling is higher, the distance between the bottom of the fixture and the table should increase slightly. Remember that the chandelier should provide light for the table, but not be so low as to block anyone’s line of vision when they are sitting at the table.

Add the room dimensions together. If the room is 14′ by 16′, add 14 + 16. The answer is 30, which means that your chandelier should be approximately 30″ in diameter. Again, remember that other factors such as the height of the ceiling may influence the proper size. For very high ceilings, you may want to go a little larger.

Generally, sconces should be placed on a wall 60″ from the floor.

Yes, they do. Each of our sconces and chandeliers are shipped hard wired, ready for installation.

Yes, we powder coat all our outdoor lighting fixtures at no additional charge. This will extend the life of all finishes and is extremely important when located near the ocean or in harsh climates.

This may only apply to lighting fixtures to be installed outdoors. Indoor lighting powder coating may incur additional charges, as it is not always necessary for indoor wrought iron lighting fixtures.

Browse all works of iron

Browse our extensive collection of fine custom iron lighting fixtures.